Mazda CX-9 Grand Touring 2009 Manual page 709

2008 BRAKES Dynamic Stability Control/Roll Stability Control - Mazda CX-9
Al -
AJ -
Power supply
AK (ABS motor
operation)
Power supply
AL (solenoid
operation)
FRONT ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION
1. When removing the right front ABS wheel-speed sensor, perform the following procedure.
1. Remove the coolant reserve tank installation bolts and move the coolant reserve tank. (See
COOLANT RESERVE TANK REMOVAL/INSTALLATION [MZI-3.7] .)
2. Remove the power steering reserve tank installation bolt and nut, and move the power steering
reserve tank. (See POWER STEERING OIL PUMP REMOVAL/INSTALLATION .)
2. When removing the left front ABS wheel-speed sensor, perform the following procedure:
1. Remove the air cleaner case. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION
[MZI-3.7] .)
3. Remove in the order indicated in the table.
Fig. 16: Identifying Front ABS Wheel Speed Sensor Connector, Front ABS Wheel Speed Sensor,
Bolt & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
4. Install in the reverse order of removal.
2008 Mazda CX-9 Grand Touring
- -
- -
Battery Voltage
Battery Voltage
- -
- -
Under any
B+
condition
Under any
B+
condition
-
-
Wiring harness
(AK- battery)
Wiring harness
(AL- battery)