Mazda CX-9 Grand Touring 2009 Manual page 114

2. Disconnect the negative battery cable and wait for 1 min or more .
3. Remove the following parts:
1. Trunk box (See TRUNK BOX REMOVAL/INSTALLATION .)
2. Seat side box (See SEAT SIDE BOX REMOVAL/INSTALLATION .)
3. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
4. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
5. Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT
REMOVAL/INSTALLATION .)
6. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
4. Remove in the order indicated in the table.
Fig. 25: Identifying Side Air Bag Sensor No. 2, Connector & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
5. Install in the reverse order of removal.
6. Turn the ignition switch to the ON position and hold for 10 s or more .
7. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
If the air bag system warning light does not operate normally, refer to the on-board diagnostic
system (air bag system) and perform inspection of the system. (See FLOWCHART .)
CLOCK SPRING REMOVAL/INSTALLATION
1. Disconnect the negative battery cable and wait for 1 min or more .
2. Remove the following parts:
1. Driver-side air bag module (See DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION.)
2. Steering wheel (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
3. Column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
3. Remove in the order indicated in the table.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Air Bag System - Mazda CX-9