POSSIBLE CAUSE
DIAGNOSTIC PROCEDURE
DTC B1342, C1730 [DSC/RSC] DIAGNOSTIC PROCEDURE
STEP
INSPECTION
VERIFY DTC INSPECTION
Turn the ignition switch off.
1
Using the M-MDS, perform the
DTC inspection.
Are any DTCs other than B1342
and C1730 output?
VERIFY CURRENT STATUS OF
MALFUNCTION
Clear the DTC from the memory.
2
(See ON-BOARD
DIAGNOSTIC [DSC/RSC].)
Is the same DTC present?
VERIFY THAT NO DTCS ARE
OUTPUT AGAIN
Drive the vehicle at 32 km/h or
3
more.
Stop the vehicle and verify the
DTCs.
Are DTCs output again?
DTC B211B, C1279, C1280, C1281, C1282, C1516, C1517, C2769, C2770
[DSC/RSC]
DTC B211B, C1279, C1280, C1281, C1282, C1516, C1517, C2769, C2770 [DSC/RSC] DETECTION
CONDITION AND POSSIBLE CAUSE
DTC B211B, C1279, C1280, C1281,
C1282, C1516, C1517, C2769, C2770
2008 Mazda CX-9 Grand Touring
2008 BRAKES On-Board Diagnostic (DSC/RSC) - Mazda CX-9
DSC/RSC HU/CM internal malfunction
Yes
No
Yes
No
Yes
No
Combined sensor system
ACTION
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSTIC [DSC/RSC].)
Go to the next step.
Replace the DSC/RSC HU/CM, then go to the next
step.
(See DSC/RSC HU/CM
REMOVAL/INSTALLATION .)
Go to the next step.
If DTC B1342 or C1730 is output again, replace the
DSC/RSC HU/CM.
(See DSC/RSC HU/CM
REMOVAL/INSTALLATION .)
DTC troubleshooting completed.
B211B
Combined sensor internal malfunction.
C1279
There is an abnormality in the signal from the