Mazda CX-9 Grand Touring 2009 Manual page 583

NOTE:
The following procedure "WATER PUMP REMOVAL/INSTALLATION" is
performed after the engine and transaxle component is removed from the
vehicle.
1. Drain the engine oil. (See ENGINE OIL REPLACEMENT [MZI-3.7] .)
2. Remove the engine and transaxle component. (See ENGINE REMOVAL/INSTALLATION [MZI-
3.7] .)
3. Secure the engine and transaxle component using a hoist and the SST .
4. Remove the dynamic chamber and throttle body as a single unit. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION [MZI-3.7] .)
5. Remove the ignition coils. (See IGNITION COIL REMOVAL/INSTALLATION [MZI-3.7] .)
6. Remove the dipstick.
7. Remove the power steering oil pump drive belt. (See DRIVE BELT REMOVAL/INSTALLATION
[MZI-3.7] .)
8. Remove the power steering oil pump. (See POWER STEERING OIL PUMP
REMOVAL/INSTALLATION .)
9. Remove the timing chain component. (See TIMING CHAIN REMOVAL/INSTALLATION [MZI-
3.7] .)
10. Remove in the order indicated in the table.
11. Install in the reverse order of removal.
12. Start the engine and:
1. Inspect the runout and contact on the pulley and belt.
2. Inspect for engine oil, engine coolant, ATF, power steering fluid and fuel leakage.
3. Verify the ignition timing, idle speed and idle mixture. (See ENGINE TUNE-UP [MZI-3.7] .)
4. Engine accessories operation.
2008 Mazda CX-9 Grand Touring
2008 ENGINE Cooling System (MZI-3.7) - Mazda CX-9
serious injures or death and damage. Fuel can also irritate skin and
eyes. To prevent this, always complete the "Fuel Line Safety
Procedure". (See BEFORE SERVICE PRECAUTION [MZI-3.7] .)
Continuous exposure to USED engine oil has caused skin cancer in
laboratory mice. Protect your skin by washing with soap and water
immediately after working with engine oil.