1. Adjust clearance A by turning the adjusting bolt of the SST.
Clearance A 2.9 mm {0.11 in}
Fig. 22: Adjusting Clearance
Courtesy of MAZDA MOTORS CORP.
2. Crimp the wheel side small boot band using the SST. Verify that clearance B is within the specification.
If clearance B is more than the specification, reduce clearance A of the SST and crimp the boot
again.
If clearance B is less than the specification, replace the boot band, increase clearance A of the SST,
and crimp the new boot.
Clearance B 2.4-2.8 mm {0.095-0.110 in}
Fig. 23: Crimping Wheel Boot Band
Courtesy of MAZDA MOTORS CORP.
3. Verify that the boot band does not protrude from the boot band installation area.
If it does, replace the boot band and repeat Steps 2 and 3.
4. Fill the boot with the repair kit grease.
5. Adjust clearance A by turning the adjusting bolt of the SST.
Clearance A 3.2 mm {0.13 in}
2008 Mazda CX-9 Grand Touring
2008 DRIVELINE/AXLES Drive Shaft - Mazda CX-9