Fig. 16: Identifying Jiggle Pin
Courtesy of MAZDA MOTORS CORP.
O-RING INSTALLATION NOTE
1. Clean and inspect the O-ring.
Install a new O-ring if necessary.
2. Apply clean engine coolant to the O-ring.
3. Install the O-ring.
THERMOSTAT INSPECTION [MZI-3.7]
1. Inspect the thermostat for the following.
WARNING:
The valve should not open under normal temperature.
Opening temperature and valve lift
If there is a malfunction, replace the thermostat.
Thermostat initial-opening temperature 79.5-83.3°C {175.2-181.9°F}
Thermostat full-open temperature 94.5°C {202.1°F}
Thermostat full-open lift More than 8.1 mm {0.32 in}
WATER PUMP REMOVAL/INSTALLATION [MZI-3.7]
WARNING:
2008 Mazda CX-9 Grand Touring
2008 ENGINE Cooling System (MZI-3.7) - Mazda CX-9
During inspection, the thermostat and water are extremely hot
and can cause severe burns. Do not touch the thermostat and
water.
Fuel vapor is hazardous. It can very easily ignite, causing serious
injury and damage. Always keep sparks and flames away from fuel.
Fuel line spills and leakage are dangerous. Fuel can ignite and cause