Mazda CX-9 Grand Touring 2009 Manual page 699

2008 BRAKES Dynamic Stability Control/Roll Stability Control - Mazda CX-9
1. Perform "Preparation".
2. Connect the M-MDS to the DLC-2.
3. Set up an active command mode inspection according to the combination of commands below.
CAUTION:
BRAKE PRESSURE RETENTION REFERENCE CHART
Command name Understeer control inhibited Oversteer control inhibited
V_TRC_L
V_TRC_R
V_STB_L
V_STB_R
V_LF_INL
V_LF_OTL
V_LR_INL
V_LR_OTL
V_RF_INL
V_RF_OTL
V_RR_INL
V_RR_OTL
PMP_MOTOR
4. Send the command while rotating the wheel being inspected by hand in a forward direction.
5. Confirm that the wheel does not rotate easily while a DSC/RSC HU/CM operation click sound is heard.
Performing the inspection above determines the following:
2008 Mazda CX-9 Grand Touring
To protect the DSC/RSC HU/CM, the solenoid valve and the
pump motor used during active command mode stay on for only
10 s or less each time they are switched on.
Fig. 4: Connecting M-MDS To DLC-2
Courtesy of MAZDA MOTORS CORP.
Inspected wheels
LF RF
ON OFF
OFF ON
OFF
OFF
ON
OFF
OFF
ON
OFF
ON
LR RR
ON
OFF
ON
OFF
ON OFF
OFF