Mazda CX-9 Grand Touring 2009 Manual page 66

2008 RESTRAINTS On-Board Diagnostic (Restraints) - Mazda CX-9
REMOVAL/INSTALLATION .)
Is there any malfunction of the passenger-side
side air bag sensor No.2 connector?
INSPECT WIRING HARNESS BETWEEN
PASSENGER-SIDE SIDE AIR BAG SENSOR
NO.2 AND SAS CONTROL MODULE
Turn the ignition switch to the LOCK position.
Disconnect the negative battery cable and wait
for 1 min or more.
Remove the column cover. (See COLUMN
COVER REMOVAL/INSTALLATION .)
Disconnect the clock spring connector. (See
COMBINATION SWITCH
REMOVAL/INSTALLATION .)
Remove the glove compartment. (See GLOVE
COMPARTMENT
REMOVAL/INSTALLATION .)
Disconnect the passenger-side air bag module
connector. (See PASSENGER-SIDE AIR
BAG MODULE
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side front
2
seat connectors. (See FRONT SEAT
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side curtain
air bag module connectors. (See CURTAIN
AIR BAG MODULE
REMOVAL/INSTALLATION .)
Remove the B-pillar lower trim. (See B-
PILLAR LOWER TRIM
REMOVAL/INSTALLATION .)
Disconnect the driver and passenger-side pre-
tensioner seat belt connectors. (See FRONT
SEAT BELT
REMOVAL/INSTALLATION .)
Disconnect the SAS control module connectors.
(See SAS CONTROL MODULE
REMOVAL/INSTALLATION .)
Inspect the wiring harnesses between SAS
control module terminal 2AA and passenger-
side side air bag sensor No.2 terminal A, SAS
control module terminal 2AE and passenger-
side side air bag sensor No.2 terminal B for the
2008 Mazda CX-9 Grand Touring
Replace the passenger-side side air bag
sensor No.2, then go to the next step.
Yes
(See SIDE AIR BAG SENSOR NO.
2 REMOVAL/INSTALLATION .)