Mazda CX-9 Grand Touring 2009 Manual page 696

2008 BRAKES Dynamic Stability Control/Roll Stability Control - Mazda CX-9
Fig. 2: DSC/RSC System Wiring Diagram
Courtesy of MAZDA MOTORS CORP.
DSC/RSC SYSTEM INSPECTION
PREPARATION
1. Verify that battery is fully charged.
2. Turn the ignition switch to the ON position, and verify that the ABS warning light goes out after approx.
3 s.
3. Turn the ignition switch off.
4. Jack up the vehicle and support it evenly on safety stands.
5. Shift to the N position.
6. Verify that all four wheels rotate.
7. Rotate the inspected wheels by hand, and verify there is no brake drag.
If there is any brake drag, perform regular brake inspection.
If there is no brake drag, perform DSC/RSC HU/CM operation inspection.
ABS CONTROL INSPECTION
1. Perform "Preparation".
2. Connect the M-MDS to the DLC-2.
3. Set up an active command mode inspection according to the combination of commands below.
2008 Mazda CX-9 Grand Touring