2008 ENGINE PERFORMANCE Emission System (MZI-3.7) - Mazda CX-9
Fig. 5: Emission System Diagram
Courtesy of MAZDA MOTORS CORP.
FUEL-FILLER CAP INSPECTION [MZI-3.7]
LEAKAGE INSPECTION
1. Perform the following SST (Evaporative Emission System Tester 134-01049) self-test:
NOTE:
1. Verify that the gas cylinder valve is closed and the control valve located on the tester is in the
TEST position. All tester displays should be off at this time.
2. Connect the long hose (part of SST ) to the tester.
3. Connect the manifold assembly (part of SST ) to the long hose as shown.
4. Open the gas cylinder valve and verify the gas cylinder regulator left gauge reads 69-82 kPa {0.71-
0.83 kgf/cm
(preset at factory).
If not, refer to the tester operators manual to contact tester manufacturer.
2008 Mazda CX-9 Grand Touring
If the tester does not work correctly during self-test, refer to the
tester operators manual for more detailed procedures.
2
, 10-12 psi}