Mazda CX-9 Grand Touring 2009 Manual page 641

6. Remove the PLG drive unit.
7. Install in the reverse order of removal.
Fig. 16: View Of PLG Drive Unit Connector & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
POWER LIFTGATE (PLG) CONTROL MODULE REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
1. Trunk box (See TRUNK BOX REMOVAL/INSTALLATION .)
2. Seat side box (LH) (See SEAT SIDE BOX REMOVAL/INSTALLATION .)
3. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
4. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
5. Third-row seat belt lower anchor installation bolt (LH) (See THIRD-ROW SEAT BELT
REMOVAL/INSTALLATION .)
6. Trunk side trim (LH) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
3. Disconnect the PLG control module connector.
4. Remove the bolts.
5. Remove the PLG control module.
6. Install in the reverse order of removal.
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Doors and Liftgate - Mazda CX-9