Mazda CX-9 Grand Touring 2009 Manual page 429

2008 TRANSMISSION Automatic Transaxle Shift Mechanism - Mazda CX-9
SELECTOR LEVER COMPONENT INSPECTION
1. Disconnect the negative battery cable.
2. Remove the center console.
3. Remove the dashboard completely. (See DASHBOARD REMOVAL/INSTALLATION .)
4. Disconnect the selector lever component connector.
5. Inspect for continuity at the selector lever component.
If there is any malfunction, adjust the selector cable. (See SELECTOR CABLE
ADJUSTMENT.)
Fig. 18: Selector Lever Component Connector Terminals Continuity Chart
Courtesy of MAZDA MOTORS CORP.
Fig. 19: Identifying Selector Lever Component Connector Terminals
Courtesy of MAZDA MOTORS CORP.
SELECTOR CABLE ADJUSTMENT
1. Remove the center console.
2. Shift the selector lever to P position.
3. Unlock the lock piece of the selector cable (selector lever side) in the order shown in the figure.
4. Verify that the manual shaft is in P position.
2008 Mazda CX-9 Grand Touring