Section 8
Control
8.5
258
•
if it is used just for the monitoring, the switches will be listed with their actual
position names, as defined by the user (max. 13 characters).
•
if it is used for control, the switches will be listed with their actual positions,
but only the first three letters of the name will be used.
In both cases, the switch full name will be shown, but the user has to redefine it
when building the Graphical Display Editor, under the "Caption". If used for the
control, the following sequence of commands will ensure:
From the graphical display:
Chang e to the "Switche s" pag e
of the SLD by left-righ t arrows.
Sele ct switch by up-down
arro ws
../Control/SLD/Switch
SMBRREC control
WFM
Pilo t se tup
OFF
Damage control
DAL
../Control/SLD/Switch
SMBRREC control
WFM
Pilo t se tup
OFF
Damage control
DFW
IEC06000421 V3 EN-US
Figure 116:
Example 2 on handling the switch from the local HMI.
From the single line diagram on local HMI.
Selector mini switch VSGAPC
Control
Measurements
Events
Disturb ance r eco rds
Settings
Diagno stics
Test
Reset
Authori zation
Lan guage
O
I
Sele ct switch. Pre ss the
I or O key. A dialo g b ox
app ears.
The pos will not b e mod ified
(outputs will not b e activa ted) unt il
.
you press the Enter button for O.K
1MRK 511 424-UEN B
Control
Sing le Line Diagram
Comma nds
../Control/SLD/Switch
SMBRREC control
WFM
Pilo t se tup
OFF
P: Disc
N: Disc Fe
OK
Cancel
IEC06000421-3-en.vsdx
SEMOD158754-1 v3
Bay control REC650 2.2 IEC
Technical manual