Operation Principle - ABB Relion 650 Series Technical Manual

1MRK 511 424-UEN B
Name Values (Range)
PulseMode6
tPulse6
PulseMode7
tPulse7
PulseMode8
tPulse8
8.7.6
8.8
8.8.1
8.8.2
Bay control REC650 2.2 IEC
Technical manual
Unit
Pulsed -
Latched
0.01 - 6000.00 s
Pulsed -
Latched
0.01 - 6000.00 s
Pulsed -
Latched
0.01 - 6000.00 s

Operation principle

The PSTO input selects the operator place (LOCAL, REMOTE or ALL). One of
the eight outputs is activated based on the command sent from the operator place
selected. The settings Latchedx and tPulsex (where x is the respective output) will
determine if the signal will be pulsed (and how long the pulse is) or latched
(steady). BLOCK will block the operation of the function – in case a command is
sent, no output will be activated.
PSTO is the universal operator place selector for all control
functions. Although, PSTO can be configured to use LOCAL or
ALL operator places, only REMOTE operator place is used in
SPC8GAPC function.
AutomationBits, command function for DNP3.0
AUTOBITS
Identification
Function description
AutomationBits, command function for
DNP3
Functionality
Automation bits function for DNP3 (AUTOBITS) is used within PCM600 to get
into the configuration of the commands coming through the DNP3 protocol. The
Step Default
- Pulsed
0.01 0.10
- Pulsed
0.01 0.10
- Pulsed
0.01 0.10
IEC 61850
identification
AUTOBITS
Section 8
Description
Setting for pulsed/latched mode for
output 6
Pulse time output 6
Setting for pulsed/latched mode for
output 7
Pulse time output 7
Setting for pulsed/latched mode for
output 8
Pulse time output 8
GUID-C3BB63F5-F0E7-4B00-AF0F-917ECF87B016 v4
IEC 60617 ANSI/IEEE C37.2
identification device number
-
Control
SEMOD176471-4 v7
SEMOD158589-1 v3
-
SEMOD158591-5 v8
265