Function Block - ABB Relion 650 Series Technical Manual

Section 9
Logic
9.8.7.1
9.8.7.2
9.8.7.3
Table 225: PULSETIMERQT Non group settings (basic)
Name
t
320
The pulse timer function block (PULSETIMERQT) can be used, for example, for
pulse extensions or for limiting the operation time of the outputs.
PULSETIMERQT has a settable output pulse length.
When the input goes to 1, the output will be 1 for the time set by the time delay
parameter t. Then it returns to 0.
When the output changes value, the time stamp of the output signal is updated.
The supported "quality" state bits are propagated from the input to the output at
each execution cycle. A change of these bits will not lead to an updated time stamp
on the output.
PULSETIMERQT can propagate the quality, value and the time stamps of the
signals via IEC 61850.

Function block

PULSETIMERQT
INPUT
IEC15000145.vsd
IEC15000145 V1 EN-US
Figure 155: PULSETIMERQT function block
Signals
Table 223: PULSETIMERQT Input signals
Name
INPUT
Table 224: PULSETIMERQT Output signals
Name
OUT
Settings
Values (Range) Unit
0.000 - 90000.000 s
OUT
Type Default Description
BOOLEAN 0 Input signal
Type Description
BOOLEAN Output signal
Step Default
0.001 0.010
1MRK 511 424-UEN B
GUID-D930E5A7-C564-4464-B97F-C72B4801C917 v4
GUID-C0490ECF-5C4E-4F17-B628-482694C590D2 v1
GUID-4543C4C9-FAE2-4328-8DE2-4A5756A020E9 v1
PID-3810-INPUTSIGNALS v5
PID-3810-OUTPUTSIGNALS v5
Description
Pulse time length
Bay control REC650 2.2 IEC
Technical manual
PID-3810-SETTINGS v5