Access Point - ABB Relion 650 Series Technical Manual

1MRK 511 424-UEN B
Section 12
12.1
12.1.1
12.1.2
Table 370: AP_1 Non group settings (basic)
Name Values (Range)
Redundancy
IPAddress
SubnetMask
Description
PTP
PCM600Access
FTP
Table continues on next page
Bay control REC650 2.2 IEC
Technical manual
Ethernet

Access point

Introduction
An access point is an Ethernet communication interface for single or redundant
station communication. Each access point is allocated with one physical Ethernet
port, two physical Ethernet ports are allocated if redundant communication is
activated for the access point.
Device 1
AP1 AP2
SFP_301 SFP_302
IEC16000092 V1 EN-US
Figure 227: Access points, non redundant (left) and redundant communication
(right)
Settings
Unit
None -
PRP-0
PRP-1
HSR
0 - 18 IP
Address
0 - 18 IP
Address
1 - 18 -
Off -
On
Slave only
Off -
On
Off -
On
Device 1
AP3
SFP_303 SFP_301
Step Default
- None
1 192.168.1.10
1 255.255.255.0
1 Station bus
- Off
- On
- On
Section 12
GUID-6E5D2696-A8EE-43E7-A94B-69C3D0612127 v2
AP2
AP1
SFP_302
IEC16000092-1-en.vsdx
Description
Ethernet redundancy mode
IP address of the access point
Subnet mask of the access point
User editable access point description
[1-18 char]
Precision time protocol
PCM600 access
FTP and FTPS access
Ethernet
AP3
SFP_303
MANUALPID-17001 v1
473