To Disconnect A Busy Trunk - NEC UNIVERGE SV9100 Features And Specifications

Guide to Feature Programming
Program
Program Name/Description
Number
11-10-26 Service Code Setup (for System
Administrator) – Forced Trunk Disconnect
Assign the Service Code.
20-06-01 Class of Service for Extensions
Assign a Class of Service (COS) to an
extension. There are 15 Classes of Service that
can be assigned. Assign eight entries, one for
each Night Service Mode.
20-07-11 Class of Service Options (Administrator
Level) – Forced Trunk Disconnect (analog
trunk only)
Turn Off or On an extension ability to use
Forced Trunk Disconnect. This allows the
extension to disconnect an Unsupervised
Conference in progress.
System Options for Outgoing Calls – Reset
21-01-18
Dial After Failure of Trunk Access
Enable/Disable an extension user ability to
continue to dial codes or extensions after
receiving Trunk Busy. This must be Enabled for
this feature to work.
Operation

To disconnect a busy trunk:

Multiline Terminal
1. Press line key for trunk.
- OR -
Dial trunk access code (
 You hear busy tone. Trunk numbers are 001~400.
2. Dial the Service Code (not set at default).
 You hear confirmation beeps as the system disconnects the trunk.
 You can now place a call on the free trunk.
3. Press the line key for the trunk disconnected in Step 2.
- OR -
Dial the trunk access code (
Single Line Telephone
1. Dial trunk access code (
 You hear busy tone. Trunk numbers are 001~400.
2. Dial Service Code (not set at default).
 You hear confirmation beeps as the system disconnects the line.
MLT, SLT
0 ~ 9,
digits
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
0 = Off
1 = On
0 = Enable (On)
1 = Disable (Off)
9 + trunk number).
#
9 + trunk number) for the trunk disconnected in Step 2.
#
9 + trunk number).
#
514
Input Data
*
#
, Maximum of eight
Default
No Setting
Extension port
101 = Class 15
All other
extension port =
Class 1
COS 1 ~ 14 = 0
COS 15 = 1
1