NEC UNIVERGE SV9100 Features And Specifications page 107

Guide to Feature Programming
Program
Program Name/Description
Number
Location Setup – Area Code
10-02-04
Enter the local area code.
Location Setup – Trunk Access Code
10-02-05
Enter the trunk access code digits required to
place an outgoing call.
10-09-01 DTMF and Dial Tone Circuit Setup
Allocate the circuits (1 ~ 16 or 1 ~ 64) on the
GCD-CP10 for either DTMF receiving or dial
tone detection.
The GCD-CP10 has 32 resources for DTMF
receiving and Dial Tone detection. When a
GPZ-BS10 is installed there are 64 resources
available.
When Program 10-09-01 is set to 0 (Common)
and Program 14-02-10 (Caller ID) is set to 1 (Yes),
all DTMF/Dial Tone Detection resources are always
allocated to analog trunks, not analog extensions.
However, if Program 14-02-10 (Caller ID) is set to 0
(No), all DTMF/Dial Tone Detection resources can
be used for both analog trunks and analog
extensions.
11-15-03 Service Code Setup, Administrative (for
Special Access) – Backup Data Save
This service code is used to back up the
programmed data on the SRAM and Call
History to the Flash ROM.
While saving the database, it may cause
system lock up.
Input Data
Dial (maximum of eight digits)
*
#
0 ~ 9, ,
Dial (maximum of eight digits)
*
#
0 ~ 9, ,
0 = Common Use
1 = Extension Only
2 = Trunk Only
MLT
*
#
0 ~ 9, , Maximum of eight
digits
107
Default
No Setting
No Setting
Circuit/Resource
01 ~ 08 = 1
(Extensions)
Circuit/Resource
09 ~ 32 = 2
(Trunks)
Circuit/Resource
33 ~ 144 = 0
(Common)
When
GPZ-BS10 is
installed, 81 ~
144 are available
# #
9
*