Outbound Ip Connection - NEC UNIVERGE SV9100 Features And Specifications

Hide thumbs Also See for UNIVERGE SV9100:

Table of Contents

Outbound IP Connection

Outbound IP Connection for PC Programming allows the system to make a PC Pro Connection via an

outgoing call over IP, to a preprogrammed IP Address, upon receipt of an incoming CO call matching a

preprogrammed CLI. When the target number of DID incoming call matches with the service code of

'Outbound IP Connection' the SV9100 compares the received CLI with the registered CLI (Program

90-69-03). When the received caller ID and registered caller ID match, the SV9100 sends a TCP

establishment request to a waiting PCPro application. When the caller ID does not match, the call will

either step to the locations in Program 22-11-05 and Program 22-11-06 if configured or, send a busy tone

to the caller. Alternatively, via dialing service code from a Multiline Terminal, an outgoing IP connection

can be made to a waiting PCPro terminal with a preprogrammed IP Address. This allows for a

pre-authorized connection for programming purposes without using CO Lines and potentially reducing

the cost of calls for maintenance. The outgoing IP call connects by sending a TCP establishment request

to a waiting PC Programming terminal. A fixed, encrypted, user ID and password are used to verify the

If an unsuccessful connection attempt is made, this can be output as an alarm.

SV9100 system software supports Outbound IP Connection (PC Programming required).

Outbound IP Connection for programming is not available when an existing WebPro/PCPro

or station programming session is active.

SV9100 changes the port number of TCP at each connection. The range used is

61050~61099.

Outbound IP Connection Service code can be dialed across CCIS.

Outbound IP Connection to a secondary side of Net-Link is not supported.

Default Settings

System Availability

All Terminals

Required Software

Required Component(s)