NEC UNIVERGE SV9100 Features And Specifications page 364

Default Settings
Disabled
Related Features

Central Office Calls, Answering

Direct Inward Line (DIL)

Direct Inward System Access (DISA)

Off-Hook Signaling

Paging, External

Programmable Function Keys

Station Message Detail Recording

Transfer
Guide to Feature Programming
Program
Program Name/Description
Number
10-03-01 ETU Setup
Set up and confirm the basic configuration data
for each blade. This program represents
different data depending on the blade installed
in the slot.
10-09-01 DTMF and Dial Tone Circuit Setup
If the system has DTMF DID trunks, be sure to
reserve at least one circuit for analog trunk
DTMF reception (type 0 or 2). There must be
an available receiver for each DTMF DID trunk.
Use the following as a guide when allocating
DTMF receivers:
In light traffic sites, allocate one DTMF receiver
for every 10 devices that use them.
In heavy traffic sites, allocate one DTMF
receiver for every five devices that use them.
Trunk Group – Trunk group Number
14-05-01
Put DID trunks in the same trunk group (other
than group 1). If you have different types of
DID trunks, put each type in a separate trunk
group.
Input Data
The assigned data varies
depending on the blade installed
in the slot.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Trunk Port 1 ~ 400 =
Priority 1 ~ 400
364
Default
Circuit/Resource
01 ~ 08 = 1
(Extensions)
Circuit/Resource
09 ~ 32 = 2
(Trunks)
Circuit/Resource
33 ~ 144 = 0
(Common)
When
GPZ-BS10 is
installed, 81 ~
144 are available
Default = Trunks
1 ~ 400 assigned
to trunk group 1
with priorities
equal to the
trunk number.
Trunk 1 = Priority
1 Trunk 400 =
Priority 400.