NEC UNIVERGE SV9100 Features And Specifications page 902

Program
Program Name/Description
Number
22-02-01 Incoming Call Trunk Setup
Set the feature type for the trunk you are
programming. For each Night Service mode,
enter 5 when the trunk should be an E&M tie
line.
E&M Tie Line Basic Setup – DID/E&M Start
34-01-01
Signaling
Set the start signaling mode for DID and Tie
trunks. They can use either immediate start or
Wink start signaling.
E&M Tie Line Basic Setup – E&M Dial-In
34-01-03
Mode
Determine if the incoming Tie Line call should
be directed as an intercom call or if it should
follow the DID Translation Table in Program
22-11-01.
E&M Tie Line Basic Setup – E&M Line Dial
34-01-04
Tone
Enable if the Tie Line should send dial tone to
the calling system after the call is set up.
Disable if the Tie Line should not send dial tone.
E&M Tie Line Basic Setup – System Toll
34-01-05
Restriction
Determine if an incoming Tie Line call should
be subject to Toll Restriction.
34-02-01 E&M Tie Line Class of Service
Assign the Tie Line Class of Service (1 ~ 15).
Use Program 20-14-01 to set the Tie Line Class
of Service options. You cannot use Program
20-06 to assign Class of Service to Tie Lines.
34-03-01 Trunk Group Routing for E&M Tie Lines
Assign the trunk group route chosen when a
user seizes a Tie Line and dials 9. Set Trunk
Group Routing in Program 14-06-01. If the
system has ARS, dial 9 to access ARS.
34-04-01 E&M Tie Line Toll Restriction Class
If the system uses Toll Restriction, enter a Toll
Restriction Class (1 ~ 15) for each Tie Line. The
system uses the class you enter in Program
21-05 and 21-06. Make a separate Toll
Restriction Class entry for each night service
mode. You cannot use Program 20-06 to assign
Toll Restriction to Tie Lines.
Input Data
0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
0 = 2nd Dial Tone
1 = Wink (default)
2 = Immediate
3 = Delay
0 = Specify Extension Number
(Intercom)
1 = Use Conversion Table (NTT)
0 = Disable (No)
1 = Enable (Yes)
0 = No (Off)
1 = Yes (On)
Day/Night Mode
1 ~ 8
Class: 1 ~ 15
0 ~ 100
(0 = No Setting)
1 ~ 15
902
Default
0
1
0
1
0
1
1
2