Isdn – Pri Installation - NEC UNIVERGE SV9100 Features And Specifications

Basic Trunk Data Setup – Sending Caller
14-01-36
Name on Outgoing Calls (ISDN Trunk)
Disable/Enable sending the Caller Name on
outgoing ISDN trunks.
Basic Extension Data Setup – Sending
15-01-10
Caller Name on Outgoing Calls (ISDN Trunk)
Disable/Enable sending the Caller Name on
outgoing ISDN calls per station.
System Options for Caller ID – Calling Party
20-19-09
Name for ISDN Trunk
Enter the Calling Party Name to be used
system wide for outgoing ISDN calls.
If no data is entered, it will follow the station
name in Program 15-01-01.
21-12-01 ISDN Calling Party Number Setup for Trunks
– Calling Party Number Data
Assign Calling Party Numbers for each trunk
(maximum 16 digits per entry).
After the above programming is complete a
reset of the GCD-2BRIA is required.
ISDN – PRI Installation:
Program
Program Name/Description
Number
ETU Setup (PRTA PKG Setup) – Layer 3
10-03-04
Timer Type
Set up and confirm the Basic Configuration
data for each CD-PRTA This program selects
the Layer 3 timer type (1 ~ 5). Each timer value
of Layer 3 is set up for each type in Program
81-06 (T-Bus).
ETU Setup (PRTA PKG Setup) – Length of
10-03-06
Cable
Set up and confirm the Basic Configuration
data for each GCD-PRTA. Select the length of
cable to be used.
ETU Setup (PRTA PKG Setup) – Dial
10-03-08
Sending Mode
ISDN protocol definition. Select either enblock
or overlap sending.
0 = Disable
1 = Enable
0 = Disable
1 = Enable
Maximum of 12 characters.
Maximum of 16 characters
#
(1 ~ 0, *, )
Input Data
1 ~ 5
0 = Level 1
1 = Level 2
2 = Level 3
3 = Level 4
4 = Level 5
0 = Enblock Sending
1 = Overlap Sending
800
0
0
No Setting
No Setting
Default
1
2
0