Resident System Program - NEC UNIVERGE SV9100 Features And Specifications

Hide thumbs Also See for UNIVERGE SV9100:

Table of Contents

Resident System Program

When power is supplied to the system, the hardware configuration is scanned and Resident System

Program default values are assigned including terminal types (e.g. PGD(2)-U10 ADP, DSS Console).

This enables immediate operation, even before the system is programmed to accommodate the

individual site requirements.

Default assignments for multiline terminals are: LK 01~LK 08 corresponds to

CO 01~CO 08.

DSS Console to Extension assignments for Attendant Add-On Consoles are not assigned.

Default Attendant Add-On Console key assignments are:

DSS Keys = 001~060

Stations = 101~160

First Initialization of the system returns all programming values to default. Without a

PC-ATA USB Drive installed, press and hold the SW1 (Load Switch) and toggle the Reset

(SW2) switch. Continue to hold the SW1 switch for approximately 5~10 seconds before

releasing. The system boots loading Resident System Programming.

Default Settings

System Availability

Required Component(s)