NEC UNIVERGE SV9100 Features And Specifications page 787

Program
Program Name/Description
Number
SIP Server Information Setup – Default
10-29-03
Proxy IP Address
Enter the default Proxy IP Address if the SIP
carrier is using an IP address for the proxy. In
most cases, this is left at the default entry as
the domain name is used.
SIP Server Information Setup – Default
10-29-04
Proxy Port Number
Define the Proxy Port Number.
SIP Server Information Setup – Registrar
10-29-05
Mode
This program is used to Enable/Disable the
ability to Register to the ITSP.
In Registration mode (IP or Domain Name)
this MUST be enabled.
SIP Server Information Setup – Registrar IP
10-29-06
Address
Define the Registrar IP Address. The carrier
may provide an IP address. In most cases, a
domain name is used so this entry is left at the
default.
SIP Server Information Setup – Registrar
10-29-07
Port Number
Define the Registrar Port Numbers.
SIP Server Information Setup – SIP Carrier
10-29-14
Choice
Define the SIP Carrier Choice.
Selecting Carrier B automatically sets
Program 10-29-16 to on (1). Program 10-29-16
MUST be set to off for incoming calls to route using
the lowest available trunk port.
Each certified vendor my use a different carrier
type. Visit NTAC website (http://www.necntac.com)
to verify the proper setting per vendor.
SIP Server Information Setup – NAT Router
10-29-21
If the SV9100 is connecting to the SIP Carrier
using NAT Translations, this setting must be
enabled.
SIP Trunk Registration Information Setup –
10-36-01
Registration
Enable/Disable the SIP trunk registration.
Input Data
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
(Profile 1 ~ Profile 2)
0 ~ 65535
(Profile 1 ~ Profile 2)
0 = None
1 = Manual
(Profile 1 ~ Profile 2)
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
(Profile 1 ~ Profile 2)
0 ~ 65535
(Profile 1 ~ Profile 2)
0 ~ 26
1 ~ 26 =
Carrier Type A ~ Carrier Type Z
(Profile 1 ~ Profile 2)
0 = Not Used
1 = Used
(Profile 1 ~ Profile 2)
0 = Disable
1 = Enable
(Profile 1 ~ Profile 2)
787
Default
0.0.0.0
5060
0
0.0.0.0
5060
0
0
0