NEC UNIVERGE SV9100 Features And Specifications page 71

Program
Program Name/Description
Number
Dial Analysis Table for ARS/LCR – Dial
26-02-01
Enter the digits (16 digits maximum: 1 ~ 9, 0 *
#
, @; 2000 separate entries) for the Dial
Analysis Table which is analyzed by ARS/LCR.
This table is checked after any programmed
F-Route operations have completed. The
system then refers to Program 26-02-02 and
Program 26-02-03 to determine the routing for
the call. To enter a wild card/don't care digit,
press Line Key 1 to enter an @ symbol. It is
important to remember that the system checks
the table numbers in numerical order. This
means that entries for specific numbers should
be entered first (such as your local area codes),
then enter the items containing wild card digits.
If the system sees an entry of 2@@, any table
entries which follow are ignored.
For example, if 268, 269, and 270 are local
exchanges, these would be the first three table
entries which route according to the settings
made in Program 26-02-02 and Program
26-02-03 for each of the table entries. If the
next entry is 2@@, the system checks no
further in this program and routes all other 2xx
numbers according to the entries made in
Program 26-02-02 and Program 26-02-03 for
this table entry.
Dial Analysis Table for ARS – ARS Service
26-02-02
Type
For each Dial Analysis Table (1 ~ 2000), select
0 for no ARS, 1 for Service Type 1 – Route to
Trunk Group Number to have the number route
to a trunk group [Refer to Program 26-02-03] or
2 for Service Type 2 – F-Route Selected to
have the dialed number controlled by the
F-Route table. If Service Type 2 is selected and
F-Route operation is on, the F-Route table used
is determined by Program 44-04. If F-Route
operation is off, the routing is determined by
Program 44-05.
Input Data
Dial a maximum of 16 digits
#
(0 ~ 9, * , @)
0 = No Service (Call Restricted)
1 = Route to Trunk Group
2 = Select F-Route Access
71
Default
No Setting
0