NEC UNIVERGE SV9100 Features And Specifications page 197

Related Features

Alphanumeric Display

Automatic Route Selection (ARS)

Call Appearance (CAP) Keys

Code Restriction

Dial Tone Detection

Handsfree Answerback/Forced Intercom Ringing

Long Conversation Cutoff

Microphone Cutoff

Programmable Function Keys

Trunk Groups

Trunk Group Routing
Guide to Feature Programming
Program
Program Name/Description
Number
10-03-XX ETU Setup
Use program 10-03-XX to setup and confirm
the basic configuration data for each blade.
This program represents different data
depending on the blade installed in the slot.
11-01-01 System Numbering
Set system numbering plan.
11-09-01 Trunk Access Code
If required, change the single-digit Trunk
Access Code (normally 9). If you change this
code, you must also review the settings in
Program 11-01-01 for the new code selected.
Trunk Access Code – 2nd Trunk Route
11-09-02
Access Code
Assign the Service Code set up in Program
11-01-01 for Alternate Trunk Route Access.
11-10-27 Service Code Setup (for System
Administrator) – Trunk Port Disable for
Outgoing Calls
Define the service code which should be used
by an extension user to block a trunk from
being used for outgoing calls.
Input Data
The assigned data varies
depending on the blade installed
in the slot.
Dial (maximum of four digits)
Dial (maximum of four digits)
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
197
Default
9
No Setting
745