NEC UNIVERGE SV9100 Features And Specifications page 108

Program
Program Name/Description
Number
Speed Dialing Number and Name – Large
13-04-13
LED Illumination Setup by (CID)
Define the color the large LED will blink when
Incoming call with matching Caller ID is
received.
This feature applies only to ITL and ITZ
terminals. DTL and DTZ terminals do not support
Large LED Illumination by CID.
Basic Trunk Data Setup – Block Outgoing
14-01-20
Caller ID
Enable/Disable the system from automatically
blocking outgoing Caller ID information when a
user places a call. If allowed (i.e. block,
enabled), the system automatically inserts the
Caller ID block code (defined in 14-01-21)
before the user dialed digits.
If prevented (i.e., block disabled), the system
outdials the call just as it was dialed by the user.
Basic Trunk Data Setup – Caller ID Block
14-01-21
Code
Enter the code, up to eight digits, that should be
used as the Caller ID Block Code. This code is
automatically inserted before dialed digits if
Program 14-01-20 is set to '1'.
Basic Trunk Data Setup – Caller ID to Voice
14-01-22
Mail
Enable/Disable the system ability to send the
Caller ID digits to voice mail.
Basic Trunk Data Setup – Trunk-to-Trunk
14-01-24
Outgoing Caller ID through Mode
This command is for PRI and SIP trunks only
and should never be enabled on any other
trunk type. When this command is enabled the
system will pass the originating callers caller ID
on to the Telco if the call is forwarded out of the
system.
Some Telco offices do not support this and will
replace the number you send them with the main
billing number.
Analog Trunk Data Setup – Caller ID
14-02-10
Enable (1) or Disable (0) a trunk to receive
Caller ID information.
Multiline Telephone Basic Data Setup –
15-02-08
Automatic Handsfree
Set whether pressing a key accesses a
One-Touch Key (1) or preselects the key (0).
Input Data
1 = Not used
2 = Red
3 = Green
4 = Blue
5 = Yellow
6 = Purple
7 = Light Blue
8 = White
9 = Rotation
0 = No Setting
Trunks 1 ~ 400
0 = Disable
1 = Enable
Trunks 1 ~ 400
Dial (maximum of eight digits)
Trunks 1 ~ 400
0 = Disable
1 = Enable
0 = Disable (No)
1 = Enable (Yes)
Trunks 1 ~ 400
0 = No
1 = Yes
0 = Preselect
1 = One-Touch (Automatic
Handsfree)
108
Default
No Setting
0
*67
0
0
0
1