NEC UNIVERGE SV9100 Features And Specifications page 792

Caller ID information. If the Caller ID information is restricted, the telephone display shows
PRIVATE. If the system cannot provide Caller ID information because the Telco information is not
available, the display shows OUT OF AREA.
Conditions
Primary Rate Interface (PRI):
The system is compatible with ISDN Primary Rate Interface (PRI) services. PRI services
currently supported include:
Basic PRI Call Control (BCC)
Display of incoming caller's name and number when allowed by Telco
Routing in the system based on the number the caller dialed
ISDN maintenance functions (such as In Service/Out of Service Messaging)
Speech and 3.1 KHz audio
PRI ability requires the installation of GCD-PRTA. Each PRI circuit provides 24 PRI
channels (23B + D) 4 with 64K Clear Channel response. The T1/PRI Interface uses a single
slot. When installed, the T1/PRI Interface uses the first block of 24 consecutive trunks. For
example, if you have an GCD-4COTA
Interface automatically uses trunks 9~32. If you have GCD-4COTA
for trunks 1~8 and 17~24, the T1/PRI uses trunks 25~48. The T1/PRI Interface cannot use
trunks 9~16 (even if available) since they are not part of a consecutive block of 24 trunks.
When using Mobile Extension in a NetLink Network, the ISDN/PRI must be utilized in the
Primary System.
If fractional PRI has the number of ports changed, the Trunk Port number might change
if they become split or fit into an empty gap of trunk ports. For example, if you have a
GCD-4COTA
+
was assigned as 25~36 and the PRI is changed to be eight ports instead of 12 ports,
the new
trunk port numbers would be 9~16 because the eight ports can now fix into the gap without
being split ports. Another example, if you have a GCD-4COTA
ports 1~8 and 17~24 and the PRI (8 ports) was assigned as 9~16 and then you change the
PRI to be 12 ports instead of eight, the new trunk ports would be 25~36 because the ports
have to be split to keep the original port numbers, and this is not supported.
If using a CSU/DSU, Program 10-03-13 must be set to 0. If not using a
CSU/DSU, Program 10-03-13 must be set to 1~7 or anything other than 0.
Restrictions for Calling Party Name:
The UNIVERGE SV9100 supports receiving the name from the Network in supported
formats only. Refer to Restrictions for Calling Party Names.
+
GPZ-4COTE for Trunks ports 1~8 and 17~24 and the PRI (12 ports)
792
GPZ-4COTE installed for trunks 1~8, the T1/PRI
GPZ-4COTE installed
+
GPZ-4COTE for Trunks
+