To Set Dial Block - NEC UNIVERGE SV9100 Features And Specifications

Guide to Feature Programming
Program
Program Name/Description
Number
11-10-17 Service Code Setup (for System
Administration) – Dial Block by Supervisor
Assign a service code used by the supervisor to
set Dial Block for another extension.
11-11-33 Service Code Setup (for Setup/Entry
Operation) – Dial Block
Assign a service code to use for Dial Block.
20-06-01 Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to
extensions.
20-08-08 Class of Service Options (Outgoing Call
Service) – Toll Restriction Dial Block
Turn Off or On an extension user ability to use
Dial Block.
21-07-01 Toll Restriction Override Password Setup
Assign Toll Restriction Override codes to
extensions. Each code must have four digits,
using any combination of 0 ~ 9,
extension can have a separate code, or many
extensions can share the same override code.
Dial Block Setup – Toll Restriction Class
21-09-01
with Dial Block
Assign a Code Restriction COS (1 ~ 15) when
the Dial Block feature is used.
Dial Block Setup – Supervisor Password
21-09-02
Assign a 4-digit password used by the
supervisor to enable or disable Dial Block for
other extensions.
21-10-01 Dial Block restriction Class per Extension
Assign the Code Restriction COS (1 ~ 15) used
by an extension when the Dial Block feature is
enabled. If this data is 0, Code Restriction COS
follows Program 21-09-01.
90-19-01 Dial Block Release
Enter the extension number to release from the
Dial Block Restriction. This program can be
used when a password is forgotten by the user.
Operation

To set Dial Block:

1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 700 (default).
MLT
*
#
0 ~ 9, ,
digits
MLT, SLT
*
#
0 ~ 9, ,
digits
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
0 = Off
1 = On
Maximum of four digits (fixed)
#
and *. Each
1 ~ 15
0 ~ 9, *, #
(4-digit fixed)
0, 1 ~ 15
(0 = No Setting)
[Release?]: Dial 1+ press
Transfer
(Press Transfer to cancel.)
242
Input Data
Maximum of eight
Maximum of eight
Extension port
101 = Class 15
All other
extension port =
Class 1
COS 1 ~ 15 = 0
Default
701
700
No Setting
15
No Setting
0
No Setting