NEC UNIVERGE SV9100 Features And Specifications page 903

Program
Program Name/Description
Number
34-05-01 Tie Line Outgoing Call Restriction
Build a restriction matrix for outgoing trunk calls
placed over a Tie Line. For each Tie Line trunk
group, Enable/ Disable outgoing access to each
CO trunk group.
Add/Delete Digit for E&M Tie Line – Delete
34-06-01
Digit
Some Tie Line networks pass the location
number and extension number to the remote
side. If the system should ignore these digits,
use this program to define the number of digits
which should be deleted for a call.
Add/Delete Digit for E&M Tie Line –
34-06-02
Additional Dial Digits
If a Tie Line network requires additional digits to
reroute the call to a location, enter the digits for
the location which should be added to the
received digits.
E&M Tie Line Timer – First Digit Pause (E&M
34-07-01
Immediate Start)
Define the First Digit Pause (E&M Immediate
Start) timer.
E&M Tie Line Timer – First Digit Pause (E&M
34-07-02
Wink Start)
Define the First Digit Pause (E&M Wink Start)
timer.
E&M Tie Line Timer – First Digit Pause (LD
34-07-03
Trunk)
Define the First Digit Pause (LD Trunk) timer.
E&M Tie Line Timer – LD Trunk Guard Time
34-07-04
Define the LD Trunk Guard Time.
E&M Tie Line Timer – Trunk Answer Detect
34-07-05
Timer for E&M
Define the Trunk Answer Detect Timer for E&M
timer.
34-08-01 Toll Restriction Data for E&M Tie Lines
Define the toll restriction data for E&M Tie Lines
if required. This must be defined if toll restriction
is enabled in Program 21-05-13.
DTMF Tone Receiver Setup – Detect Level
80-03-01
Use Items 11~32 to set the criteria for dial tone
detection for outgoing ARS calls.
Input Data
0 = Enable (Y-Tandem)
1 = Disable (N-Tandem)
0 ~ 255
(255 = delete all digits)
Maximum of four digits
#
(0 ~ 9, *, )
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
0 ~ 64800 seconds
Maximum of 10 digits
#
(0 ~ 9, *, )
0 = 0dBm ~ -25dBm
1 = -5dBm ~ -30dBm
2 = -10dBm ~ -35dBm
3 = -15dBm ~ -40dBm
4 = -20dBm ~ -45dBm
5 = -25dBm ~ -50dBm
6 = -30dBm ~ -55dBm
903
Default
0
0
No Setting
3
0
3
0
30
No Setting
Type 1 ~ 5 = 0