NEC UNIVERGE SV9100 Features And Specifications page 982

Outbound IP Connection:
Program
Program Name/Description
Number
10-03-01 ETU Setup
Set up and confirm the basic configuration data
for each blade. This program represents
different data depending on the blade installed
in the slot.
11-15-16 Service Code Setup, Administrative (for
Special Access) – Outbound IP Connect for
Programming
Assign the service code for Outbound IP
Connection for Programming. This Service
Code is used to invoke TCP establishment
request from SV9100 to remote PCPro.
System Alarm Setup – Alarm Type
90-10-01
Indicates the alarm type for Failure of Outbound
IP Connection for PC Programming.
Firmware Update Time Setting – Firmware
90-36-01
Update Schedule Time
Read Only program.
Firmware Update Time Setting – Update
90-36-02
Mode
Read Only program.
Firmware Update Time Setting – Update
90-36-03
Report
Read Only program.
Outbound IP Connection Setup – Port
90-69-01
Number
Define the port number used for Outbound IP
Connection for Programming.
Input Data
The assigned data varies
depending on the blade installed
in the slot.
0 = Not Set
1 = Major Alarm
2 = Minor Alarm
Year: 0 ~ 99
Month: 0 ~ 12
Day: 00 ~ 31
Hour: 00 ~ 23
Minute: 00 ~ 59
0 = Non Active
1 = Activated
Maximum of 256 characters.
1 ~ 65535
982
Default
No Setting
Alarm 58:
Failure of
Connection
(Outbound IP
Connection)
Adding
parameter:
01:
Programming
session is
already active
02: Not setting of
IP Address or
Port
03: Caller ID is
not match.
10: Failure of
getting IP
Address.
11: Socket Open
Error 12: Socket
Port Setting
Error.
13: TCP Session
Timeout
No Setting
No Setting
No Setting
8000