NEC UNIVERGE SV9100 Features And Specifications page 120

Guide to Feature Programming
Program
Program Name/Description
Number
11-10-32 Service Code Setup (for System
Administrator) – Set Private Call Refuse
Enable/Disable the Private Call Refuse (trunks)
which are set in Program 14-01-27.
11-10-33 Service Code Setup (for System
Administrator) – Entry Caller ID Refuse
Add/Delete the Caller ID to refuse.
This operation must be performed from a
Keyset.
11-10-34 Service Code Setup (for System
Administrator) – Set Caller ID Refuse
Enable/Disable the Caller ID number (trunks)
which are set in Program 14-01-27.
13-02-01 Group Speed Dialing Bins
Designate the starting and ending bin numbers
the system uses for Group Speed Dialing.
Speed Dialing Number and Name – Speed
13-04-01
Dialing Data
Enter the System and Group Speed Dialing
numbers and names.
Speed Dialing Number and Name – Transfer
13-04-03
Mode
When the incoming caller ID matches the
number programmed in the speed dial bin, this
setting determines the destination of the call.
Input Data
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
MLT
*
#
0 ~ 9, , Maximum of eight
digits
MLT, SLT
*
#
0 ~ 9, , Maximum of eight
digits
01 ~ 64
0 ~ 9999
Starting bin number range:
0 ~ 9990
Ending bin number range:
0 ~ 9999
*
Maximum of 24 digits (0 ~ 9,
#
, @, P, R)
@ = Wait for Answer
Supervision - ISDN trunks only
P = Pause - Analog Trunk Only
R = Hook flash - Analog Trunk
Only
0 = Not Used
1 = Internal Dial
2 = Incoming Ring Group (IRG)
120
Default
No Setting
No Setting
No Setting
No Setting
,
No Setting
0