Built-In Brake Relay Usage Selection - YASKAWA SGD7S-xxxDA0 series Product Manual

6.11 Holding Brake

6.11.5 Built-in Brake Relay Usage Selection

• When the Time Set In Pn508 Elapses after the Power Supply to the Motor Is Stopped
Controlword
(6040h), alarm,
or power OFF
Motor speed
Motor power status
Important

6.11.5 Built-in Brake Relay Usage Selection

SERVOPACKs with built-in brake control contain a brake relay.
Set Pn023 = n.
brake relays.
Pn023
(2023h)
6-36
Enable
Operation
Power
supplied.
ON (Brake released.)
/BK signal
Pn508
The Servomotor will be limited to its maximum speed even if the brake reference output speed
level (Rotary Servomotor: Pn507, Linear Servomotor: Pn583) is higher than the maximum speed.

X (Built-in Brake Relay Usage Selection) to specify whether to use the built-in
Parameter

n. 0
Use the built-in brake relays.
(default setting)

n. 1 Do not use the built-in brake relays.
Disable
Operation
Rotary Servomotor: Pn507
Linear Servomotor: Pn583
Motor stopped with dynamic
brake or by coasting
(Pn001 = n.
Power not
supplied.
OFF (Brake applied.)
Description
X)
When Enabled Classification
After restart Setup