Page 1
SI-EN3 and SI-EN3/V EtherNet/IP Option Product Demonstration Unit Technical Manual Document: TM.AFD.08 12/28/2010 Rev: 10-12...
Page 2
The setup will now be discussed in detail. 2.1 Drive Demo Case This DEMO is intended to support and demonstrate A1000 (SI-EN3) or V1000 (SI-EN3/V) AC Drives with the EtherNet/IP option board properly installed. No special drive software is required. The HMI and CompactLogix L32E programs are loaded and operational as shipped from Yaskawa.
Page 3
2.2 PC and an Internet Browser Although a PC is not technically required to show EtherNet/IP communication with this demo, it is a perfect opportunity to demonstrate the EtherNet/IP card’s webpage. Looking at the webpage also confirms that the card is properly functioning. Configure the PC’s IP address to be compatible with the EtherNet/IP card (use 192.168.1.19 as instructed).
Page 4
Communications ⇒ Setup screen shown above. For ease of use, fill out the spreadsheet using MS Excel. The file is located in C:\Program Files\Yaskawa\Drive Wizard. The file is called IPList.csv. Make sure to leave the file in the “.csv” format.
Page 5
5.0 Network Comparison Table Feature Modbus TCP/IP EtherNet/IP DeviceNet Part Number SI-EM3 SI-EN3 SI-N3 Network Type Request / Response Produced / Consumed I/O Protocol Type Controller Level Device Level Speed 10/100Mbps 125-500kpbs Nodes Unlimited Number of Masters Multiple Webpage Deterministic...
Need help?
Do you have a question about the SI-EN3 and is the answer not in the manual?
Questions and answers