Installing The Routing Engine Re-Ptx-X8-64G; Figure 269: Installing The Cb2-Ptx Control Board - Juniper PTX5000 Hardware Manual

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

Installing the Routing Engine RE-PTX-X8-64G

To verify that the Control Board is installed correctly and functioning normally:

a. Connect an Ethernet cable to the

the host subsystem is operational, the

activity. If you can run the CLI from a management device attached to the Control

Board, the Control Board is installed correctly.

b. Verify that the green

LED should light steadily a few minutes after the Control Board is

c. Verify that the

LED on the Control Board faceplate is not lit. If the

lit steadily, remove and install the Control Board again. If the

steadily, the Control Board is not functioning properly. Contact your customer

support representative.

d. To verify that the Control Board is

To install the Routing Engine (see

Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the

ESD points on the chassis.

Ensure that the ejector handles are not in the locked position. If necessary, press the

red tabs and flip the ejector handles outward.

Place one hand underneath the Routing Engine to support it. With the other hand,

grasp one of the ejector handles on the faceplate.

Chapter 30: Upgrading to RE-PTX-X8-64G Routing Engines

HOST/ETHERNET

port LED is lit to indicate Ethernet

LED on the Control Board faceplate is lit steadily green.

Figure 270 on page

port on the Control Board. If

LED still lights

show chassis environment cb

Table of Contents