Replacing A Compactflash Card In A Ptx5000 Routing Engine; Removing A Compactflash Card From A Ptx5000 Routing Engine - Juniper PTX5000 Hardware Manual

Packet transport router
Hide thumbs Also See for PTX5000:
Table of Contents

Advertisement

Related
Documentation

Replacing a CompactFlash Card in a PTX5000 Routing Engine

Removing a CompactFlash Card from a PTX5000 Routing Engine

Copyright © 2017, Juniper Networks, Inc.
PTX5000 Routing Engine Description on page 76
PTX5000 Routing Engine LEDs on page 80
Routing Engines Supported on PTX Series Routers on page 82
Removing a CompactFlash Card from a PTX5000 Routing Engine on page 393
1.
Installing a CompactFlash Card in a PTX5000 Routing Engine on page 394
2.
Copying the Junos OS to the CompactFlash Card in a PTX5000 Routing
3.
Engine on page 395
The CompactFlash card is located in the slot labeled
faceplate. To remove the CompactFlash card (see
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Determine whether the host subsystem is functioning as the master or as the backup,
2.
using one of these methods:
Check the
and
HOST 0
is lit, the corresponding host subsystem is functioning as the master.
Check the
LED on the Control Board. If the blue
MASTER
subsystem is functioning as the master.
Issue the following CLI command. The master Routing Engine is designated
in the
Current state
field for the Routing Engine in
user@host> show chassis routing-engine
Routing Engine status:
Slot 0:
Current state
...
If the host subsystem is functioning as the master, switch it to backup using the
3.
chassis routing-engine master switch
From the master Routing Engine, issue the
4.
other-routing-engine
to power down the backup Routing Engine.
Verify that the
Online
,
Disk1
5.
off.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
6.
the strap to one of the ESD points on the chassis.
Chapter 29: Removing and Installing Host Subsystem Components
CompactFlash
Figure 249 on page
LEDs on the craft interface. If the green
HOST 1
Master
command.
request system power-off
, and
CF
LEDs on the backup Routing Engine faceplate are
on the Routing Engine
394):
MASTER
LED is lit, the host
MASTER
Slot 0
:
request
LED
Master
393

Advertisement

Table of Contents
loading

Table of Contents