Connecting Power To The Ptx5000 High Capacity Single-Phase Ac Pdus; Figure 135: Connecting Power To The High Capacity Wye Ac Pdu - Juniper PTX5000 Hardware Manual

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

Documentation

Connecting Power to the PTX5000 High Capacity Single-Phase AC PDUs

Verify that the AC power wiring connections are correct.

Close the door to the metal AC wiring compartment, and use a number 2 Phillips (+)

screwdriver to tighten the two captive screws to secure the door to the metal AC

wiring compartment.

Verify that the AC power cord does not touch or block access to PTX5000 components,

and that it does not drape where people could trip on it.

Repeat the procedure for the other High Capacity Wye AC PDU.

Understanding Normal-Capacity Power System Power Zones on page 71

PTX5000 AC Power System Description on page 42

Powering On the Three-Phase AC-Powered PTX5000 Packet Transport Router on

Powering Off the PTX5000 on page 495

The high-capacity single-phase AC PDU accepts eight single-phase 30-A or eight

single-phase 20-A, 200–250 VAC L-L input power. One 30-A or 20-A input power provides

dedicated input power to each PSM.

Chapter 21: Connecting the Router to Power

Table of Contents