Removing The Control Board; Figure 264: Removing A Control Board - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Removing the Control Board

414

Figure 264: Removing a Control Board

To remove a Control Board (see
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the
2.
ESD points on the chassis.
Label and disconnect the cables.
3.
Rotate the ejector handles counterclockwise on both sides of the Control Board
4.
faceplate.
Grasp the ejector handles and slide the Control Board about halfway out of the chassis.
5.
Place one hand underneath the Control Board to support it and slide it completely
6.
out of the chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Figure 264 on page 414):
Copyright © 2017, Juniper Networks, Inc.