Copyright © 2017, Juniper Networks, Inc.
Grasp the front installation handle on the PDU faceplate and pull the handle firmly
9.
down toward you. Slide the PDU halfway out of the chassis until you can reach the
top installation handle. (See
Use the top and front installation handle to slide the PDU completely out of the chassis.
10.
CAUTION:
Each PDU weighs approximately 60.5 lb (27.4 kg). Be prepared
to support the full weight of the PDU as you remove it from the packet
transport router.
WARNING:
Do not touch the power connectors on the rear of the PDU. They
can contain dangerous voltages.
CAUTION:
Do not leave a PDU slot empty for more than a short time while
the packet transport router is operational. For proper airflow, the PDU must
remain in the chassis or a blank panel must be used in an empty slot.
Figure 233: Removing a High Capacity Single-Phase AC PDU
Chapter 27: Removing and Installing Power System Components
Figure 233 on page
363.)
363