Juniper PTX5000 Hardware Manual page 211

Copyright © 2017, Juniper Networks, Inc.
Carefully slide the PTX5000 onto the mounting shelf, so that the bottom of the chassis
4.
and the mounting shelf overlap by approximately 2 inches.
With four people pushing on the front-mounting flanges, slide the PTX5000 onto the
5.
mounting shelf until the center-mounting brackets (open-frame racks) or
front-mounting flanges (four-post racks) contact the rack rails. The shelves ensure
that the holes in the center-mounting brackets and the front-mounting flanges of the
chassis align with the holes in the rack rails.
Visually inspect the alignment of the PTX5000. If the chassis is installed properly in
6.
the rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side, and the chassis should be level.
Install a mounting screw into each of the mounting holes aligned with the rack, starting
7.
from the bottom.
Move the lift away from the rack.
8.
Chapter 17: Installing the Router into a Rack
175