Juniper PTX5000 Hardware Manual page 533

Copyright © 2017, Juniper Networks, Inc.
Repeat steps 3 and 4 for the other PDU.
5.
Verify that the PDU OK
6.
LEDs are off for your specific PDU:
120-A DC PDU—Verify that the
60-A DC PDU—Verify that the
Three-phase delta AC PDU or three-phase wye AC PDU—Verify that the
is off.
NOTE: After powering off a power supply, you must wait at least 60
seconds before powering it on again.
LED on the PDU faceplate is off. Verify that these additional
LED is off.
CB ON
SW ON LED is off.
Chapter 36: Powering Off the Router
CB ON
LED
497