Engine; Figure 250: Installing A Routing Engine Compactflash Card - Juniper PTX5000 Hardware Manual

Copying the Junos OS to the CompactFlash Card in a PTX5000 Routing Engine
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Reinstall the Routing Engine cover and tighten the screws on the corners of the cover
5.
to secure it to the Routing Engine (using a number 2 Phillips (+) screwdriver).
From the master Routing Engine, issue the
6.
command to power on the Routing Engine.
other-routing-engine
NOTE: You may get an error message and be prompted for a keystroke.
After you press the keystroke, it might take up to 10 minutes for the Routing
Engine to reset and for the router to boot from the solid-state disk.

Figure 250: Installing a Routing Engine CompactFlash Card

After installing the CompactFlash card for the first time, you must copy the software
from the Routing Engine's solid-state disk (SSD) to the CompactFlash card.
To copy software to the CompactFlash card:
On the console or other management device connected to the Routing Engine, enter
1.
CLI operational mode, and copy the currently running and active file system partitions
on the router to standby partitions on the CompactFlash card. Issue the
snapshot partition command.
Wait until a message appears on the console confirming that the snapshot partition
2.
procedure is complete.
Issue the
request system reboot
3.
Issue the
show system boot-messages
4.
card is listed as the primary boot device. The output lists the devices mounted. The
CompactFlash card is located at
PTX5000 Routing Engine Description on page 76
PTX5000 Routing Engine LEDs on page 80
Troubleshooting the PTX5000 Routing Engines on page 522
Prevention of Electrostatic Discharge Damage on page 611
Chapter 29: Removing and Installing Host Subsystem Components
request system power-on
command to reboot the router's software.
command to verify that the CompactFlash
.
ad0
request system
395