Powering On The Router; Powering On The Dc Powered Ptx5000 Packet Transport Router With 60-Adc Pdus And 60-A Dc Psms - Juniper PTX5000 Hardware Manual

CHAPTER 22

Powering On the Router

Powering On the DC Powered PTX5000 Packet Transport Router with 60-A DC PDUs
and 60-A DC PSMs
Copyright © 2017, Juniper Networks, Inc.
Powering On the DC Powered PTX5000 Packet Transport Router with 60-A DC PDUs
and 60-A DC PSMs on page 243
Powering On the DC Powered PTX5000 Packet Transport Router with 120-A DC PDUs
and 120-A DC PSMs on page 245
Powering On the DC-Powered PTX5000 Packet Transport Router with High Capacity
DC PDUs and High Capacity DC PSMs on page 247
Powering On the Three-Phase AC-Powered PTX5000 Packet Transport
Router on page 249
Powering On the Single-Phase AC-Powered PTX5000 Packet Transport
Router on page 250
To power on the DC-powered PTX5000 with 60-A DC PDUs and 60-A DC PSMs:
NOTE: After powering off a power supply, you must wait at least 60 seconds
before powering it on again.
Verify that the power distribution units (PDUs) and power supply modules (PSMs)
1.
are fully inserted in the chassis and that the captive screws on the faceplates are
tightened.
Verify that an external management device is connected to one of the Routing Engine
2.
ports on the Control Board (
NOTE: The management Ethernet port labeled
Control Board is not available until after the initial software configuration.
You can monitor the startup process during the initial installation using
devices connected to the
Turn on power to the external management device.
3.
AUXILIARY or CONSOLE ).
AUXILIARY or CONSOLE
on the
HOST/ETHERNET
ports.
243