Upgrading To The High Capacity Ac Power System - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide
Related
Documentation

Upgrading to the High Capacity AC Power System

376
PDU 0 PSM 5 status:
State
Temperature
Fans
DC Input
DC Output
Hours Used
Firmware Version
PDU 0 PSM 6 status:
State
Temperature
Fans
DC Input
DC Output
Hours Used
Firmware Version
PDU 0 PSM 7 status:
State
Temperature
Fans
DC Input
DC Output
Hours Used
Firmware Version
PTX5000 DC Power System Description on page 33
Before you upgrade a PTX5000 to the High Capacity AC power system from a
normal-capacity power system:
Ensure that the
No Redundant Power for System
the show chassis alarms
If the
No Redundant Power for System
Normal-Capacity Power System Power Zones" on page 71
PTX5000 redundancy and power zones for normal-capacity PSMs. Modify your
hardware configuration so that the PTX5000 power system is redundant. Once
redundant power is configured and the alarm is no longer displayed, you can begin the
upgrade procedure.
Ensure that the PTX5000 is running Junos OS release 14.1R2 or a later 14.1 release, or
Junos OS release 14.2 or later.
NOTE: If you are upgrading from normal-capacity Delta or Wye AC PDUs,
you must begin this procedure with the left PDU when viewed from the rear
of the chassis (labeled
Online
OK 37 degrees C / 98 degrees F
OK
OK
OK
69
01.46
Online
OK 38 degrees C / 100 degrees F
OK
OK
OK
68
01.46
Online
OK 36 degrees C / 96 degrees F
OK
OK
OK
69
01.46
alarm is not displayed when you run
operational-mode CLI command.
alarm is displayed, see
on the chassis).
PDU1
"Understanding
for more information about
Copyright © 2017, Juniper Networks, Inc.