Installing A Ptx5000 Pic Cfp2 Transceiver - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Installing a PTX5000 PIC CFP2 Transceiver

446
Arrange the cable in the cable management system to prevent it from dislodging or
5.
developing stress points. Secure the cable so that it is not supporting its own weight
as it hangs to the floor. Place excess cable out of the way in a neatly coiled loop in
the cable management system. Placing fasteners on the loop helps to maintain its
shape.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Pull the ejector latch to the extreme end away from the CFP2 transceiver faceplate
6.
to unseat the CFP2 transceiver from the PIC. Pull the CFP2 transceiver out of the PIC
and place it on the antistatic mat or in the electrostatic bag.
NOTE: You cannot remove the transceiver until you move the ejector latch
to the extreme end.
To install a replacement CFP2:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Verify that a rubber safety cap covers the CFP transceiver, installing one if necessary.
2.
Orient the CFP2 over the port in the PIC so that the connector end will enter the slot
3.
first and the CFP2 connector faces the appropriate direction.
Slide the CFP2 into the slot. If there is resistance, remove the CFP2 and flip it so that
4.
the connector faces the other direction.
Remove the rubber safety cap from the transceiver and the end of the cable, and
5.
insert the cable into the transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and
prevents accidental exposure to laser light.
Copyright © 2017, Juniper Networks, Inc.