Copyright © 2017, Juniper Networks, Inc.
Label and disconnect the cables.
3.
Remove the Routing Engine from the Control Board.
4.
Rotate the ejector handles counterclockwise on both sides of the Control Board
5.
faceplate.
Grasp the ejector handles and slide the Control Board about halfway out of the chassis.
6.
Place one hand underneath the Control Board to support it and slide it completely
7.
out of the chassis. Place it on the antistatic mat.
CAUTION:
Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Figure 256: Removing a Routing Engine from a Control Board
Chapter 29: Removing and Installing Host Subsystem Components
403