CHAPTER 26
Removing and Installing Cooling System
Components
Replacing a PTX5000 Horizontal Air Filter
Removing a PTX5000 Horizontal Air Filter
Copyright © 2017, Juniper Networks, Inc.
Replacing a PTX5000 Horizontal Air Filter on page 269
Replacing a PTX5000 Vertical Air Filter on page 273
Replacing a PTX Series PIC Air Filter on page 276
Replacing a PTX5000 Power Supply Module Air Filter on page 279
Replacing a PTX5000 Horizontal Fan Tray on page 280
Replacing a PTX5000 Vertical Fan Tray on page 283
Removing a PTX5000 Horizontal Air Filter on page 269
1.
Installing a PTX5000 Horizontal Air Filter on page 271
2.
The horizontal air filter is located below the lower horizontal fan tray. The horizontal air
filter weighs approximately 7.1 lb (3.2 kg).
To remove the horizontal air filter:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the two captive screws on the horizontal air filter tray.
2.
Grasp the head of the loosened screws, and pull to remove the air filter tray (see
3.
Figure 146 on page
270).
Locate the two areas, near each rear corner, where the air filter tray is exposed. Using
4.
these air filter tray frame access areas, slide the air filter toward the air filter tray
faceplate, and pull up on the air filter to release the rear edge of the air filter from the
air filter tray (see
Figure 147 on page
271).
269