Juniper PTX5000 Hardware Manual page 354

PTX5000 Packet Transport Router Hardware Guide
318
Switch on the customer-site circuit breaker to the PDU.
14.
Verify that the 200-240 V ~ 60 A 50-60 Hz
15.
indicating that the PDU is receiving voltage.
Reinstall the PSMs into the PDU.
16.
Loosen the captive screws on the door covering the PSMs and open the door.
a.
Place one hand underneath the PSM to support it and slide it into the PSM slot.
b.
Push the ejector handle toward the PSM, and tighten the captive screw on the
c.
ejector handle to secure it to the PSM.
Repeat these steps for the other PSMs in the PDU.
d.
Move the circuit breaker on the PDU to the on (|) position.
17.
Verify that the LED on the PDU faceplate is lit steadily.
18. CB ON
Move the power
19. OUTPUT
Verify that the LED and
20. AC IN
lit steadily, indicating that each PSM is receiving power. Verify that the
off.
Verify that the PDU OK
21.
PDU is functioning normally.
LED on the PDU faceplate is lit steadily,
switch on the PDU to the on (|) position.
LED on the faceplate of each PSM in the PDU are
DC IN
LED on the PDU faceplate is lit steadily, indicating that the
LED is
FAULT
Copyright © 2017, Juniper Networks, Inc.