Table 97: Troubleshooting Sib Alarms - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Table 97: Troubleshooting SIB Alarms

Alarm
Type LCD Message
Red SIB sib-number Failure
550
3.3 V
0.9 V
2.5 V
3.3 V bias
...
In Table 97 on page 550, the text in the column labeled "LCD Message" appears in the
display of the craft interface. The text in the column labeled "CLI Message" appears in
the output from the
show chassis alarms
CLI Message
SIB sib-number
Fault
3299 mV
900 mV
2500 mV
3339 mV
command.
Alarm Condition
A SIB has failed. This might affect
traffic-forwarding capacity.
Copyright © 2017, Juniper Networks, Inc.
Recovery
Replace the failed SIB.
Restart the SIB. If this does
not fix the issue, contact
JTAC.