Figure 229: Connecting The Metal Retaining Bracket And Ac Power Cord To The - Juniper PTX5000 Hardware Manual

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

Using a number 2 Phillips (+) screwdriver, loosen the two captive screws on the metal

AC wiring compartment of the replacement PDU. Open the metal door of the metal

AC wiring compartment.

Gently push the wires of the AC power cord into the area for the metal retaining bracket,

and pull the wires to the left toward the metal AC wiring compartment.

Using a number 2 Phillips (+) screwdriver, tighten the four captive screws on the metal

retaining bracket to secure the AC power cord to the PDU. See

Figure 229: Connecting the Metal Retaining Bracket and AC Power Cord

to the High Capacity Wye PDU

Chapter 27: Removing and Installing Power System Components

Figure 229 on page

Chapters

Table of Contents